Two cables (A and B) are needed for the RGB signals, one for composite video.
Thread the cables through the back of the junction box and out of the front.
Carefully cut off the terminating RJ-45 connector from each cable.
Strip the insulator of each cable wire back approximately 0.4" (1.1 cm).
Following the wiring diagram and table below, use a Tweeker to press down the spring switch,
and insert each wire into its correct location in the connector on the rear panel of the applicable
PVT. Release the spring to hold the wire securely in place.
Cut off the
RJ-45 connector.
2 3 4 5 6 7 8
Press to hold the spring open.
Insert the wires according to
Release to close the spring.
PVT RGB CV MK and PVT RGB MK Installation Guide, cont'd
Where applicable, connect an IR cable from the MediaLink Controller to the rear IR connector
by inserting the signal wire into the hole marked "S", and the ground wire into the
hole marked "G" (see inset, step 6).
Tighten down the screws.
Push all excess wiring into the box.
9. Using the supplied screws, attach the wall plate directly to the junction box.
10. Connect the applicable input device and, where applicable, an IR emitter to the PVT.
11. Power on the input device and the Polevault switcher.
The PVT wall plate is powered by the PoleVault switcher
Refer to the "PoleVault System Installation Guide" to complete system installation and setup.
Double Wide
Dry Lining Box
Extron Electronics, USA
800.633.9876 714.491.1500
www.extron.com
FAX 714.491.1517
Strip the insulator
White-green
White-orange
White-brown
PVT RGB CV MK
RGB and Composite
Line Driver
3.5 x 30 mm
Extron Electronics, Asia
Extron Electronics, Europe
+800.7339.8766 +65.6383.4400
+800.3987.6673 +31.33.453.4040
FAX +65.6383.4664
FAX +31.33.453.4050
RGB Signals
Wire Color
Extron Electronics, Japan
+81.3.3511.7655
FAX +81.3.3511.7656
Systems can
Wire Color
Video Signals
White-orange
White-green
White-brown
Extron electronics p/n 26-448-01 mbc evc buffer user guide (2 pages)
Polevault system a/v source inputs vga computer-video, composite video, and audio source inputs (4 pages)
Vga line driver (2 pages)
Active modules for audio buffering, video line driving, twisted pair transmission, control and power output (12 pages)
Hideaway surface access products (30 pages)
Ip link accessory with four relays (1 page)
Table mountable maap bay for three maaps (1 page)